Ktag 2.22 master Ktag firmware V7.003 Ktag KTM100 V2.22 No tokens limited
OBD2Tuning.com V2.22 Ktag ecu programming tool KTM100 KTAG 2.22 master china using tips:
1. Do not run the original software on our hardware, otherwise the hardware may be damage.
2. Please Disconnect Internet While Using KTAG, Otherwise It Will Get Damaged
3. KTM100 all options are gray, there are two possible reasons, you may run the original software, or the tokens are used up.
4. DO NOT use anti-virus software.
Chinese KTM100 fw V7.003 sw V2.22/ V2.13 can do while other ECU tools can’t:
1. KTM100 can read the encrypted ECU computer, while Ktag can’t, for example one user tested Ktag V5.001 failed to read encrypted BOSCH MEV1746BMW(P171).
2. KTM100 can read the encrypted ECU computer, e.g BMW N55 N20 and BENZ
3. KTM100 and KTAG can perform CHEKSUM, while KESS V2 can’t.
What is CHECKSUM? Generally speaking, if you want to add power, firstly use KTAG/KTM100 read out the data, then edit the data, then use KTAG/KTM100 to perform checksum, finally write into ECU.
Get checksum error? How to fix? The answer is : usually, check the data via KTAG/KTM100.
OBD2Tuning.com KTM100 KTAG 2.22 master china Ktag 7.003 Firmware reset tokens:
Shown as the following picture, just press this token to reset tokens.
Use tips: press this button, meanwhile connect to the power supply. If you just press this button, but not connect to the power, it won’t work, because the factory consider the case that if you press this button carelessly, it may result in data read failure or writing failure.
This article is compiled by www OBD2Tuning com, if you have any advice on it, pls feel free to contact OBD2Tuning - China OBD2 Tuning Tool Automotive Diagnostic Tools Car Key Programmer OBD2 ECU chip tuning tool Center.
沒有留言:
張貼留言