Tactrix openport 2.0 rev e Tactrix openport 2.0 usb cable
We include a USB cable with each obd2tuning.com Tactrix openport 2.0 tuning interface, which is all the hardware you'll need unless you have one of the few vehicles that require a separate reflash adapter. For Subaru you'll only need a reflash adapter for the 2001 through 2005 WRX, but not STi, unless you're working on an early non USDM STi in which case you made need one of our WRX adapters. No other Subaru vehicles require reflash adapters including Forester, Baja, Legacy, or naturally aspirated Impreza models. For Mitsubishi, you'll need the adapter for most pre CAN vehicles which include the 5-9 Evo. Choose the adapter you need from the 'Reflash Adapters' drop down list on the bottom of this page.
OBD2Tuning.com Tactrix Tuning wrx Technical Details:
72Mhz 32-bit processor
USB 2.0 full speed device (USB-A/Mini cable included)
Field upgradeable software
Supports these major OBD protocols:
CAN 2.0 (CAN/ISO15765)
K-line (ISO9141/ISO14230(KWP2000)/dual K line)
J2534 PassThru support with Windows DLL
Standalone datalogs to microSD / microSDHC card without a laptop
Able to apply GND or 5V-25V to OBD pins 1,3,9,11,12,13 or AUX 2.5mm stereo connector
Able to log from Innovate Motorsports 2.5mm stereo MTS data bus
RGB status LEDs
It has been successfully tested with the following software: Chiploader, MMC Flasher, Multiflasher, PCM Flash, Toyota Techstream and many others.
This article is compiled by www OBD2Tuning com, if you have any advice on it, pls feel free to contact OBD2Tuning - China OBD2 Tuning Tool Automotive Diagnostic Tools Car Key Programmer OBD2 ECU chip tuning tool Center.
Focus on OBD Tool Since 2008
Facebook page: https://www.facebook.com/obd2tuning/
沒有留言:
張貼留言